Actron CP9575 User Manual

CP9575Actron AutoScanner®OBD II Scan Tool

ViewDataallowsthefollowingitemstobeviewedontheTool:  Sensor data  Operation of switches  Operation of solenoids  Operation of relaysMul

PID DenitionsNOTE: The Tool only displays the PIDs the vehicle supports.Tool Description Tool DescriptionABS FRP Absolute Fuel Rail PressureIGNADV

Tool Description Tool DescriptionCOOLANT Engine Coolant PTO STATUS Power Take Off StatusEGR CMD Commanded Exhaust Gas RecirculationREL FRP Relative Fu

Safety PrecautionsThis User’s Manual describes the features of the Tool and provides step-by-step instructions for operating the Tool. Always refer to

• Always turn the ignition key OFF when connecting or disconnecting electrical components, unless otherwise instructed.• Most vehicles are equipped

the whereabouts of the connector.  ERASE keyPerforms the Erase Codes function and scrolls forward through the screens. Press this key when

4. Plug the OBD II Connector attached to the Tool into the vehicle connector. The Tool automatically reads Codes and I/M Monitors and dis-plays the

a faulty component or system. Pending DTCs convert to Diagnostic Trouble Codes when an emissions problem persists long enough to be considered a re

MIL StatusMIL (Malfunction Indicator Lamp) status indicates if the vehicle com-puter is telling the MIL to illuminate when the engine is running. • M

 Since DTCs Cleared - shows status of the monitors since the DTCs were last erased.  This Drive Cycle - shows status of monitors since the start o

System SetupSystem Setup allows: • Display contrast to be changed,• Tool information to be viewed,• Display to be checked,• Operation of the keypa