OPERATINGINSTRUCTIONSBattery Load TesterTest Time: 10 seconds Max Time: 15 secondsDigital 130 Amp Battery Load/Alternator TesterLoad Switch12.32
2When Working on Vehicles Always wear approved eye protection. Always operate the vehicle in a well-ventilated area. Do not inhale exhaust
3Battery Load TesterThe Battery Load Tester is a hand-held, diagnostic tool used to test 12V (volt) and6V lead-acid type automotive batteries. A 10-se
4Vehicle Battery1. Turn ignition key OFF; not in the ACCESSORIESposition (Figure 2). Engine needs to be OFF andall electrical loads must be removed f
53. Press and hold the LOAD SWITCH for10 seconds. Refer to Figure 4.4. Observe the voltage on the LCD andnote the value. Release the LOADSWIT
6 Battery clamps are securely fastened to the terminals. Terminals are clean and free of debris for a good electrical continuity. If a side-post
73. Have an assistant turn the ignition switch to the Start Position and crank enginefor 15 seconds. If working alone, use a remote starter switch. Do
8©2002Printed in China0002-000-2407Figure 7 Alternator Test SetupAlternator TestThis test identifies problems associated with the alternator.1. As sh
Comments to this Manuals