Actron CP9135 Specifications download pdf (Page 16)

3-3

Using the Tool

If one DTC is retrieved, the AutoScanner will display the DTC number

and type (MIL or pending) on the top line, and the definition on the

bottom. If more than one DTC is present, the top line will also display

the code index (n/x), i.e. 1 of 3. This and the DTC number will alternate

on the display while the bottom line shows the definition.

If the definition is longer than the display, it will continuously scroll to

the left. To freeze the scrolling message, press and hold the ENTER

key. Use the

▲ or ▼ keys to view each DTC. When done, press the

BACK key to return to the Main Menu.

• Definitions for Generic (or Global) DTCs will be displayed on the

bottom line. These definitions can be found in the vehicle’ service

manual (refer to Section 2.6 - Vehicle Service Information or

on the enclosed product CD).

If no DTCs are present, the message

“PASS, No Codes Returned” will

display. Press the BACK key to

return to the Main Menu.

Do not disconnect the AutoScanner until codes have been

recorded. When power is removed, the AutoScanner’s memory

is cleared.

3.3 Erase Codes

The Erase Codes function deletes the DTCs from the vehicle’s

computer memory. Perform this function only after the systems have

been checked completely and DTCs have been documented. This

function should be performed with KOEO - Do not START engine.

After servicing the vehicle, delete the stored DTCs and verify no codes

have been reset. If DTCs return, the problem has not been corrected

or other faults are present.

In addition to clearing DTCs, the Erase Codes function resets

the status of the I/M System Monitors to “Not Ready.”

P0452 

EVAP Emission Cont [

1 of 3 

ion Control System [

PASS 

No Codes Returned

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 119 120

No comments

Actron CP9135 Specifications Page 16